To restore the default cost value, use the no form of this command. To specify a cost for the default summary route sent into a stub or NSSA, use the area default-cost command in router configuration mode or IPv6 router configuration mode.
#CLEAR ARP CACHE CISCO ASA ASDM HOW TO#
The following example shows how to enable MD5 authentication for area 1:Ĭiscoasa(config-router)# area 1 authentication message-digestĬiscoasa(config-router)# Related Commands Including the message-digest keyword enables MD5 authentication.
#CLEAR ARP CACHE CISCO ASA ASDM PASSWORD#
Entering the area authentication command without the message-digest keyword enables simple password authentication. If the specified OSPFv2 area does not exist, it is created when this command is entered. (Optional) Enables Message Digest 5 (MD5) authentication for the area specified by the area_id. Valid decimal values range from 0 to 4294967295. You can specify the identifier as either a decimal number The identifier of the area for which authentication is to be enabled. No area area_id authentication Syntax Description To disable area authentication, use the no form of this command.Īrea area_id authentication To enable authentication for an OSPFv2 area, use the area authentication command in router configuration mode. The following example shows how to create an OSPF area with an area ID of 1:ĭefines the area as a not-so-stubby area.ĭisplays the commands in the global router configuration. Use the related area commands to set the area parameters. The area that you create does not have any parameters set. The following table shows the modes in which you can enter the command: You can specify the identifier as either a decimal number or an IP address. To remove the area, use the no form of this command. To create an OSPF v2 or OSPFv3 area, use the area command in router configuration mode. authorization-server-group (tunnel-group general-attributes).authorization-server-group (imap4s, pop3s, smtps) (Deprecated).authentication-server-group (tunnel-group general-attributes).authentication-server-group (imap4s, pop3s, smtps) (Deprecated).
0 kommentar(er)
